Kayak Cart

It is a little loose, but it should work fine.

That's what she said.   

You beat me to it insayn...I was going to say, "Yeah, that's what my ex said" 

Wouldn't it be great if you could have those things re-sleeved like a Chevy Vega 

Following all of the advice here I made my hard wheel setup for my Hobie cart today. Instead of PVC I ended up using the hard plastic pipe that is used as part of a lawn irrigation system. The nice thing is that I could buy one 8" piece for less than a buck and use it for the set offs for both sides.

Also I am not sure of the others' wheels but mine have no bushing just a hole through the plastic. When I looked at the Harbor Freight Tools in Cedar Hills these looked like the best choice ($6.99 a piece). The entire addition ended costing about $19. I may need to thin the clips a bit as the wire is a bit thicker than the width of the groove.

 

Looks good!

That turned out looking good.  It should be much easier getting up that launch at George Rogers.

Great job Pdx.