Team Challenge: Junk Jigs rules posted pics begin

Sounds like team "?" Captain nobaddays is looking to get some team mates for a New to be named  team and if not your more then welcome to join team C.O.D. Nice jig  and when your done bleeding your catch you can swab the deck before sending it back down.

SwageLok fitting, DOT tape, Zip Ties, Epoxy
5.35 ounces, just at 12 inches. 

Looks like it should hook lings. Nice idea.

Looks like a lightsaber !

Any of the old hands have a pic of the beer bottle cap jig polepole & co used in Alaska a few years back?

Here's my creation for team COD.  "Pinkzilla"

Mike,

There is no doubt that jig is going to show a lot of action in the water.

It is going to be fun to see which ones actually get bit.

Still working on it but hers my oversized blade bait 2˝oz.

It's going to be fun to try to catch fish on these master crafted junk jigs.  I'm hoping mine won"t be a rock magnet.

I am on a team of one, but here is my first contribution.  I call it moptapus.  It is made with a double hook, pencil lead, mop strands, hog rings and paracord.  It is approximately six inches long. Guaranteed to catch a ling.

Dang! That looks fishy!

My first attemp at this... a light switch pull chain.  It was hollow so I hammered a .45ACP 185gr LSWC into the base for some added heft.

My first feeble attempt. Needs more bling, I think.

With February off to a good start I haven't seen any junk jigs from team INSAYN or any other freshly started teams? Remember 3 jigs per person and the end of the month we will get our judges to go threw the pictures and decide the human decisions. Later we will let the bottom fish be the true judges. Also no modifying them after the final judgment, it goes in the water as it was judged.  Can't speak for Insayn but team C.O.D. will take new members there's an age restriction for members but NOT for mascots  . Although mascots are required to wear a funny hat at least two times on the water and photos are a must.

Pinstriper Make sure you don't leave it on your night stand! Might work for steelhead to.

Sorry, my other priorities have been owning my time.  I have the workings of two jigs in a pile in the garage, but with my free time I have been gearing up my AI for this years fishing season, as well as a few trips up to the mouth of the Deschutes for sturgeon. 

If I don't lollygag too much longer, I will try and get at least two done this week.   

As for the "INSAYN fishing team", nobody else has showed much interest.  Whatta team, right?   

Open seats are always welcome.